Robopac Ecoplat Base - Maintenance Information; Maintenance Instructions; Maintenance Period Table

- 37 -
English
C724153200.fmIDM
Chapter 7
MAINTENANCE INFORMATION 2
7.1. MAINTENANCE INSTRUCTIONS
Danger - Warning
The chapter refers only the operations that can be performed directly by the op-
erator.
If actions or operations not described in the chapter are necessary, contact a
Service Centre authorised by the Manufacturer.
Before performing any maintenance and adjustment, activate all foreseen safe-
ty devices and evaluate the need to warn operating personnel and those in the
near vicinity. In particular, adequately mark the surrounding areas and prevent
access to all devices that could, if activated, cause unexpected personal safety
hazards.
7.2. MAINTENANCE PERIOD TABLE
Keep the machine in maximum working conditions and perform the pro-
grammed maintenance operations advised by the manufacturer. Good mainte-
nance achieves the best machine performance, longer machine life and
constant observance of the safety regulations.
(*)
The reduction gears and gear motors can be lubricated with grease, oil or with permanent lubrication. Refilling and/or change shall
not be performed in case of permanently lubricated reduction gears and gear motors.
Table 7.1: Maintenance intervals
Frequency Component Type of intervention Procedure Reference
Every 40 hours machine Cleaning
Clean with a cloth or
jet of air
-
Every 200
hours
Rubber coated rollers Cleaning Clean with alcohol -
Lifting chain
Greasing -
See "lubrication point
diagram"
Check tension Adjust
See "reel carriage
lifting chain
adjustment"
Table rotation chain
Greasing -
See "lubrication point
diagram"
Check tension Adjust
See "table rotation
chain adjustment"
Reduction gears and
gear motors
Inspection of the
lubricant level (*)
Refill, if necessary,
with a lubricant of the
same type.
See "Lubricant table"
Every 2000
hours
Lifting chain Wearing check - -
safety devices Check efficiency - -
Table rotation chain Wearing check - -
Every 5000
hours
Revolving table
wheels
Replace -
See "replacing
rotating table wheels"
Carriage lifting wheels Replace - -
Reduction gears and
gear motors
Lubricant change (*)
Use lubricants with
equal characteristics.
See "Lubricant table"
Evers GmbH Graf-Zeppelin-Str. 10 46149 Oberhausen Telefon +49 208 99475-0 Telefax +49 208 99475-31 evers@eversgmbh.de eversgmbh.de