Roche cobas b 221 system

Roche Diagnostics May 2009
F-4 Service Manual · Version 9.0
Index cobas b 221 system
–Tubing paths, C-8
Delete all databases, B-13
Delete databases & archives, B-13
Demo mode, B-6
Diagnostics (test routines), D-95
Disinfectant, A-7
ESD protection, A-8
Floppy disk drive
– Replacing the floppy disk drive, B-101
Fluid actions, A-11
– Aspirate sample, A-22
–Calibration, A-31
–COOX calibration, A-43
– Na conditioning, A-35
–O
2
zero point calibration, A-34
–Overview, A-13
–Sample distribution, A-23
– Sample input, A-21
FMS
– Replacing the FMS, B-33
– Replacing the FMS control board, B-35
– Replacing the FMS tubing set, B-35
– Replacing the FMS valve (MIX), B-88
General fluidics test, D-108
General hardware test, D-127
General information
– cobas bge link screen sharing, D-12
– Fill level determination, D-12
– Hard disk information, D-11
– MSS information, D-11
Hard disk
– Replacing the hard disk, B-99
Hb cartridge
– Replacing the Hb cartridge, B-63
Hemolyzer
– Replacing the hemolyzer, B-60
– Replacing the Hemolyzer tube, B-61
– Replacing the HSIN board, B-61
– Test, D-100
Hotline info, B-6
Important information, A-5
Important notes, B-19
Important notes and warnings, A-6
Interface unit
– Replacing the Interface unit, B-92
ISE measuring chamber
– Replacing the center seal, B-43
– Replacing the electrode locking lever, B-43
– Replacing the fan protector, B-43
– Replacing the ISE measuring chamber, B-42
Load default setup, B-7
Log monitor, B-11
Logon with Operator ID, B-6
Long boot time, D-94
Main fan
– Replacing the main fan unit, B-110
Mainboard unit
– Replacing the Mainboard unit, B-89
– Replacing the sample sensor board, B-91
Maintenance, C-3
– AutoQC module, C-14
– cobas b 221<1> system, C-10
– cobas b 221<2> system, C-12
– cobas b 221<3> system, C-10
– cobas b 221<4> system, C-12
– cobas b 221<5> system, C-10
– cobas b 221<6> system, C-12
Meas. sensors
– BG, D-103
– ISE, D-104
– MSS, D-105
Measurement report operator ID, B-6
Measuring chamber cartridge
– Replacing the MC Actor Control Board, B-50
– Replacing the measuring chamber cartridge, B-48
Module stops, D-37
MSS measuring chamber
– Replacing the center seal, B-47
– Replacing the electrode locking lever, B-46
– Replacing the fan protector, B-46
– Replacing the MSS clip, B-46
– Replacing the MSS MC cover, B-45
– Replacing the MSS measuring chamber, B-44
– Replacing the MSS measuring chamber amplifier, B-47
E
F
G
H
I
L
M