Rockwell Automation Publication 5069-UM003B-EN-P - January 2020 9
Chapter 1
Compact 5000 I/O Serial Module Overview
The Compact 5000™ I/O serial module provides two independent channels
that function as network interface via RS232C, RS422 or RS485 to serial
devices communicating on Generic ASCII, Modbus RTU/ASCII, DF1 or
DH-485 protocol.
The module has two channels that are independent of each other. The channels
can transmit data to and receive data from serial devices using the following
communication mode:
• Generic ASCII
• Modbus RTU/ASCII (Master/Slave)
•DF1
• DH-485
The serial module can reside locally in a CompactLogix™ 5380, Compact
GuardLogix® 5380, or CompactLogix™ 5480 system. The module can also reside
in a remote Compact 5000 I/O system accessible via an EtherNet/IP™ network.
Topic Page
Controller and Software Compatibility 10
Module Overview 11
Local I/O or Remote I/O Modules 12
IMPORTANT Use Studio 5000 Logix Designer® Version 31 or greater. You must install an
Add-On Profile to use the serial module. To find the Add-On Profile, go to the
Product Compatibility and Download Center
(PCDC).
DF1 and DH-485 must use Channel 1 and be local.
The serial module with firmware revision 2.011 and later with Add-On
profile version 2.01 supports DH-485 and DF1 protocols DF1 Point to Point,
DF1 Master, DF1 Slave, and DF1 Radio modem.
To Next Page
Loading...
Need help?
General
