198 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Chapter 7 Logic Functions
Setpoint Output Setup
The Status.Alarms table on page 348 contains a status bit that is on when each
setpoint or logic gate is active and is off when the setpoint or logic gate is not
active. You can optionally assign an output action, such as energizing a relay
output or clearing a counter. An output action does not have to be assigned.
Many applications can monitor the setpoint or logic gate status bits in the
Status.Alarms
table. The tags that are listed can optionally be used to tie output
actions to setpoints, and are found in the Configuration.Setpoint_Outputs
table
on page 320
.
Setpoint Output n Input Source
The Setpoint Output n (1, 2, …) Input Source specifies the setpoint or logic gate
to associate with the output action.
1…10 = Setpoints 1…1
11…20 = Setpoints 11…20 (M6 and M8 models)
21…30 = Level 1 Logic Gates 1…10 (M6 and M8 models)
Setpoint Output n Action
See Setpoint Output Action List on page 205 for selections.
Setpoint Reference Tables
Table 25 - Setpoint Parameter Selection List
Parameter
Number
Parameter Tag Name Units Range M5 M6 M8
0 None XXX
1 V1_N_Volts V 0…9.999E15 X X X
2 V2_N_Volts V 0…9.999E15 X X X
3 V3_N_Volts V 0…9.999E15 X X X
4 VGN_N_Volts V 0…9.999E15 X X X
5 Avg_V_N_Volts V 0…9.999E15 X X X
6 V1_V2_Volts V 0…9.999E15 X X X
7 V2_V3_Volts V 0…9.999E15 X X X
8 V3_V1_Volts V 0…9.999E15 X X X
9 Avg_VL_VL_Volts V 0…9.999E15 X X X
10 I1_Amps A 0…9.999E15 X X X
11 I2_Amps A 0…9.999E15 X X X
12 I3_Amps A 0…9.999E15 X X X
13 I4_Amps A 0…9.999E15 X X X
To Next Page
Loading...
