282 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Appendix A PowerMonitor 5000 Unit Data Tables
156 1 SINT R3CommFaultMode The Default output state on communication loss defines the behavior
of the output if the power monitor experiences a loss of
communication.
0 = Last state/resume
1 = Last state/freeze
2 = De-energize/resume
3 = De-energize/freeze
4 = Local Control
N/A 0…4
1 SINT Pad36 For alignment purpose
2 Int16 CmdWordOne These commands can be sent to the power monitor. When using the
optional elements the command table must be sent complete with all
elements present. If the single password table is used to gain access to
configuration items then the command can be sent alone without
optional settings. The command options are:
0 = No Action
1 = Set kWh Register
2 = Set kVARh Register
3 = Set kVAh Register
4 = Set kAh Register
5 = Clear All Energy Registers
6 = Set Status 1 Count
7 = Set Status 2 Count
8 = Set Status 3 Count
9 = Set Status 4 Count
10 = Force KYZ Output On
11 = Force KYZ Output Off
12 = Remove Force from KYZ
13 = Force Relay 1 Output On
14 = Force Relay 1 Output Off
15 = Remove Force from Relay 1
16 = Force Relay 2 Output On
17 = Force Relay 2 Output Off
18 = Remove Force from Relay 2
19 = Force Relay 3 Output On
20 = Force Relay 3 Output Off
21 = Remove Force from Relay 3
22 = Restore Factory Defaults
23 = Reset Powermonitor System
24 = Reserved for future use.
IMPORTANT: If a command is received that is not supported by your
catalog number, the command is ignored.
N/A 0…23
Table 45 - Configuration.Instance Data Table (continued)
Start
Byte
Size Type Tag Name Description Units Range
To Next Page
Loading...
