42 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Chapter 2 Install the PowerMonitor 5000 Unit
5. Click Properties.
6. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.
7. Select Use the following IP address, enter the IP address: 192.168.169.1.
The default subnet mask 255.255.255.0 is correct. Note: The default IP
address of the PowerMonitor 5000 unit is 192.168.169.3.
8. Then, click OK.
Your connection has now been configured and you can browse the
PowerMonitor 5000 web page by using the USB connection.
To Next Page
Loading...
