Rockwell Automation Allen-Bradley PowerMonitor 5000 Unit - Page 47

Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 47
Install the PowerMonitor 5000 Unit Chapter 2
Optional ControlNet Communication
An optional ControlNet® port can be factory-installed in PowerMonitor 5000
units with a catalog number that ends in -CNT, and can also be purchased from
Rockwell Automation and installed by you.
For information on installing the optional communication card, see the
PowerMonitor 5000 Optional Communication Modules Installation
Instructions, publication 1426-IN002
.
A ControlNet media installation includes trunk cable, taps and terminators, and
can include optional redundant media. For detailed ControlNet system
installation information, see the ControlNet Coax Media Planning and
Installation Guide, publication CNET-IN002
, and the ControlNet Network
Configuration User Manual, publication CNET-UM001
.
Figure 25
shows a simple ControlNet network installation that uses redundant
media.
Figure 25 - ControlNet Network
ATTENTION: Power must be removed from the power monitor before
inserting or removing an optional communication card. Inserting or
removing an optional communication card under power can damage the
card or the power monitor.
Virtual Wiring
Correction
---- S1
S2
---- S3
S4
---- S com
S com
---- K
Y
---- Z
R1 O
---- R1 com
R1 C
---- R2 O
R2 com
---- R2 C
R3 O
---- R3 com
R3 C
Module
status
Network
status
Cong Lock
EtherNet √IP
PowerMonitor 5000
Power
USB
Device
USB
Host
LNK
ACT
I 1
I 2
I 3
I 4
L1
L2
GND
24V
com
Scom
S n
Internal
24 VDC
K
Y
Z
Rx O
Rx com Rx C
V1
V2
V3
VN
VG
AB
ControlNet
MS