Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 51
Setup and Commands Chapter 3
Once initial setup has been completed, including configuration of the IP address,
you can also access the web interface from a computer that is connected through a
network to the PowerMonitor 5000 unit native Ethernet port. Open the Internet
Explorer browser and browse to the IP address of the unit.
How to Obtain Access to the Configuration Pages
The PowerMonitor 5000 unit initially has security that is disabled by default. If
your power monitor security is disabled, you can continue configuring the unit
without logging in.
If Security Is Enabled
If security is enabled, the web page header displays ‘Logged in as:’ and a Log in
link.
If security is enabled, log in as an administrator to configure setup parameters. If
not logged in as an administrator, you can view, but not change, configuration
parameters. If login is required, click the Log in link.
The USB connection has a special administrator account. Follow these steps to
log in with this account.
1. Type in the user name usbadmin.
2. Type in the password usbadmin.
3. Click Log In.
A dialog box reports the result.
To log in from the network web interface, select a previously configured
administrator account user name and password. The PowerMonitor 5000 unit
does not permit logging in with the USB administrator login from the network.
You remain logged in until you log out or until 30 minutes have passed since
configuration changes have been applied.
To Next Page
Loading...
