56 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Chapter 3 Setup and Commands
Configure Initial Security
If you choose to enable security on the power monitor, you must perform the
initial security configuration by using the USB web interface.
1. In the USB web page, choose the Security folder and then the Security
page.
2. From the Security Defaults pull-down menu, choose Enable Security.
3. Accept the prompt regarding whether to enable security and accept the
prompt to reload the web pages.
4. Log in with user name usbadmin and password usbadmin.
5. Accept the prompt that the login was successful.
6. To add a network administrator, click AddNew.
To Next Page
Loading...
