Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 63
Setup and Commands Chapter 3
10. Select the PowerMonitor 5000 module that corresponds to the catalog
number of your PowerMonitor 5000 unit, then click Create.
In this example, the module is created for a 1426-M8E device.
11. Enter a name and the IP address for the PowerMonitor 5000 module.
The name creates tags in RSLogix 5000 or Studio 5000 software that can
be used to read and write data from the PowerMonitor 5000 module.
12. In the Module Definition section, click Change.
The Module Definition dialog box appears.
To Next Page
Loading...
