Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 65
Setup and Commands Chapter 3
16. To create the module, click OK.
The PowerMonitor 5000 module has been created and added to the I/O
tree of the Studio 5000 project and the three controller tags have been
added: the input instance, the output instance, and the configuration
instance.
Device Setup
You must configure the PowerMonitor 5000 unit for the unit to meter and
function properly. Configuration pages in the module set-up dialog box divide
the required information into subcategories. Evaluate the system and application
and determine the appropriate configuration settings, select the applicable
configuration page from the navigation tree, and use the configuration pages to
enter the settings.
To Next Page
Loading...
