Operating the Instrument
R&S
®
RTO
76Getting Started 1316.0833.02 ─ 10
5.3 Toolbar
The toolbar provides direct access to important control and measurement functions, it
shows current date and time, and an information box with status messages of the
instrument.
A little triangle in the upper right corner of the icon means, that a menu is available
where you can select the required function.
A little square in the upper right corner of the icon means, that the function can be acti-
vated or deactivated.
By default, the toolbar shows the most frequently used functions. You can configure
the content of the toolbar and hide the date/time display, see chapter 5.3.3, "Toolbar
Configuration", on page 81.
5.3.1 Using the Toolbar
Using the toolbar is easy and straightforward.
Some of the toolbar functions are one-click actions. These actions are performed
immediately when you tap the icon.
Other toolbar functions are analyzing functions. These are interactive actions.
To use analyzing functions (interactive actions)
1. If several waveforms are shown in the diagram, tap the "Select" icon and then the
waveform that you want to analyze.
The waveform gets the focus, and the grid labels have the color of the selected
waveform.
2. Tap the icon of the function.
3. Tap the required diagram, or drag a rectangle on the diagram to mark the area to
be analyzed.
Toolbar
To Next Page
Loading...
