Rohde & Schwarz R&S RTO Series - Showing Basic Measurement Results; Performing a Cursor Measurement

Trying Out the Instrument
R&S
®
RTO
51Getting Started 1316.0833.02 ─ 10
4.7 Showing Basic Measurement Results
Using the R&S RTO you can perform and display different measurements simultane-
ously. The color of the results in the result table corresponds with the source waveform
color.
4.7.1 Performing a Cursor Measurement
1. Restore the default signal channel settings by pressing the PRESET and
AUTOSET keys.
2. Tap the "Cursor" icon on the toolbar.
3. Tap the diagram in which you want to set the cursors, or draw a rectangle on the
screen to position the cursor lines.
The cursor lines appear in the diagram and the "Cursor Results" box opens. The
measured values of the waveform at the cursor positions are displayed.
4. You can move the cursor lines in different ways:
● Touch a cursor line and drag it on the screen.
● Tap a cursor line to activate it, and turn the Navigation knob to adjust the posi-
tion.
● Enter the position values in the result box.
Showing Basic Measurement Results