Trying Out the Instrument
R&S
®
RTO
61Getting Started 1316.0833.02 ─ 10
7. To remove the FFT results, tap the "Delete" icon and then the FFT waveform.
8. Close the "Measurement" result box.
4.9 Performing Mathematical Calculations
In addition to the measured waveforms, you can display calculated data to compare
the current measurement result with.
For example, you can rescale the waveform and display it in the same diagram as the
original waveform.
1. Press AUTOSET.
2. Press the MATH key.
3. In the "Setup" tab, select the "Basic" subtab.
4. Tap the "Source1" icon and select Ch1Wfm1.
5. Tap the "Operator" icon and select Rescale.
6. For "a", enter the vertical scaling factor, e.g. 4.
Performing Mathematical Calculations
To Next Page
Loading...
