Trying Out the Instrument
R&S
®
RTO
52Getting Started 1316.0833.02 ─ 10
5. To save space in the display, minimize the result box. The most important results
are displayed and updated in the result icon, as well.
6. To remove the result icon and make room on the display for other results, tap the
red cross on the icon label.
4.7.2 Performing an Amplitude Measurement
In order to measure the voltages of a pulse quickly, perform amplitude measurements
in the time domain.
1. Restore the default signal channel settings by pressing the PRESET and
AUTOSET keys.
2. Tap the "Measurement" icon on the toolbar.
3. Tap the diagram in which you want to perform the measurement, or draw a rectan-
gle on the screen to define a gate area for which the amplitude is measured.
Showing Basic Measurement Results
To Next Page
Loading...
