Rohde & Schwarz R&S RTO Series - Saving Data

Trying Out the Instrument
R&S
®
RTO
68Getting Started 1316.0833.02 ─ 10
5. If a printer is connected to the instrument, or the instrument is connected to the
network, select an installed printer in the printer selection box. Printing to a file is
also possible using one of the "RS Printer" drivers for JPG, PDF, PNG, and TIFF
files.
6. Tap "Print" to print the image to the selected printer or printer driver. The result is a
monochrome image.
7. Tap "Save" to save the image to a file.
The result is a greyscaled image. The default file name is
Screenshot_<date>_<index>_<time>.png. It is saved to the following direc-
tory:
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
ScreenShots
4.13 Saving Data
After a measurement with the R&S RTO you can save the resulting waveform data for
further evaluation or comparison. You can also save measurement results, and device
settings in order to repeat or restore previous measurements.
●
"Saving waveform data" on page 68
●
"Saving data of an acquisition series" on page 69
●
"Saving measurement results" on page 69
●
"Saving and restoring device settings" on page 70
Saving waveform data
1. Press the FILE key on the front panel (in the SETUP area on the left).
2. Select the "Waveforms/Results" tab.
3. Check the "Source" and set "Scope" to "Full Waveform".
If a cursor, zoom or measurement gate is defined, you can use these settings to
export only a part of the waveform.
4. Under "Save to file", tap "Save As" to open the file selection dialog box.
5. The default storage directory is shown in the file selection dialog box:
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
RefWaveforms
6. Tap the keyboard icon and enter Waveform1 on the online keyboard.
7. Tap "ENTER" to close the online keyboard.
Saving Data