Rohde & Schwarz R&S RTO Series - Using the Standard Zoom

Trying Out the Instrument
R&S
®
RTO
47Getting Started 1316.0833.02 ─ 10
of the zoom functions. The instrument has 4 zoom types, 2 of them you will try out in
this chapter.
The usage of zooms is also shown in a short video that is available on the instrument:
"Tutorials > Getting Started > Zoom".
4.5.1 Using the Standard Zoom
1. Restore the default signal channel settings by pressing the PRESET and
AUTOSET keys.
2. On the toolbar, tap the "Zoom" icon.
3. Tap the position in the diagram that you want to define as one corner of the zoom
area, then drag your finger to the opposite corner of the zoom area.
While you drag your finger on the touchscreen, a dotted rectangle is displayed to
indicate the current zoom area. When the rectangle covers the required zoom
area, remove your finger.
The indicated area is magnified in a new zoom diagram. The original diagram is
displayed with the zoom area indicated as a rectangle.
Zooming into the Display