Rohde & Schwarz R&S RTO Series - Toolbar Functions

Operating the Instrument
R&S
®
RTO
77Getting Started 1316.0833.02 ─ 10
To select a function on a toolbar menu
Icons with a little triangle in the upper right corner show the last selected function. A
short tap on the icon activates the displayed function. To change the function, proceed
as follows:
1. Touch the icon and drag your finger down.
2. When the menu has opened, remove the finger.
3. Tap the required function on the menu.
The function is selected, and its icon is shown in the toolbar.
The toolbar handling is also shown in a short video that is available on the instrument:
"Tutorials > Getting Started > Toolbar".
5.3.2 Toolbar Functions
This chapter describes all toolbar functions in detail.
One-click actions Interactive actions
Undo Zoom functions
Redo Search
Show tooltips and help Cursor measurements
Show signal bar Masks
Load saveset Histogram functions
Find level Automatic measurement
Save settings Quick measurement
Save screenshot FFT
Clear screen results Select
Autoset / Preset Delete
Run Cont Label
Run Single Update reference waveform
Save waveform
You can configure the content of the toolbar and hide the date/time display, see chap-
ter 5.3.3, "Toolbar Configuration", on page 81.
The following list describes at first the default toolbar functions and then the additional
functions.
Toolbar