Operating the Instrument
R&S
®
RTO
87Getting Started 1316.0833.02 ─ 10
The results are displayed in the specified area of the screen.
3. To move the result table from the diagram back to the signal bar, tap the tab name
and drag it back to the signal bar.
To open the correspondig setup dialog box
►
In the result box, tap the icon.
The dialog box with corresponding settings opens.
To define the default position of results
1. Press the DISPLAY key on the front panel.
2. In the "Display" dialog box, select the "Diagram Layout" tab.
3. Under "Result box", select the "Default position":
● "Preview": result icon on the signal bar
● "Floating": floating result box in front of the diagrams
To adjust the font size in result boxes
1. Press the SETUP key.
2. Select the "Screen" tab.
3. Set the "Result dialog font size".
5.6 Using the Signal bar
The signal bar can hold a large number of signal and result icons. Signal icons repre-
sent the waveforms, serial buses and parallel buses, while result icons are minimized
result boxes showing measurement and search results.
To scroll the signal bar
If the signal bar contains more than four icons, not all icons are visible on the display.
► Touch one of the icons and move it up or down until the required icon appears.
To switch on and off the signal bar
If you need the complete screen to see the diagrams and results, you can switch off
the signal bar completely.
► Tap the "Show signal bar" icon on the toolbar.
Alternatively, tap "Signal Bar" on the "Display" menu.
Using the Signal bar
To Next Page
Loading...
