Rohde & Schwarz R&S RTO Series - Page 119

Operating the Instrument
R&S
®
RTO
88Getting Started 1316.0833.02 ─ 10
To change the position of the signal bar
► Touch the "Horizontal" label on the top of the signal bar and drag the it to the oppo-
site side of the screen.
To set the action on tapping the signal icon
You can define what happens when you tap a signal icon: Either the waveform is mini-
mized, or it is selected (gets the focus).
1. Press the DISPLAY key on the front panel.
2. In the "Display" dialog box, select the "Diagram Layout" tab.
3. Under "Signal bar", tap "Click on signal icon".
4. Select the action on clicking/tapping:
● "Minimize": The waveform switches from the diagram to the signal icon and is
shown as small real-time preview.
● "Hardkey logic": Selects the waveform for further operation.
To configure auto-hide
The signal bar can be hidden if the displayed information has not changed for a
defined time, and is displayed again automatically when a setting in the signal bar
changes. The signal bar does not hide entirely, it simply fades and becomes less visi-
ble in the display.
1. Press the DISPLAY key on the front panel.
2. In the "Display" dialog box, select the "Diagram Layout" tab.
3. Select "Auto-hide".
4. Define the hiding properties:
● "Hide bar after": the time after which the bar is hidden if no changes occur
● "Hiding transparency": Transparency of the hidden signal bar on a scale from
20% (low transparency) to 70% (high transparency)
● Hide head also: the horizontal and trigger labels are also faded
To change the colors
If you want to highlight the signal bar, you can change the "Fill color" and "Border
color" of the bar.
1. Press the DISPLAY key on the front panel.
2. In the "Display" dialog box, select the "Diagram Layout" tab.
3. Tap "Border color" to change the color of the signal bar frame, or "Fill color" to
change the fill color of the bar.
4. In the "Adjust Colors" dialog box, select the color to be used.
Using the Signal bar