Instrument Tour
R&S
®
RTO
30Getting Started 1316.0833.02 ─ 10
CHECKMARK
The CHECKMARK key has different functions depending on the focus:
●
In usual dialog box: if the focus is on a selection list, the key opens the list and
applies the selected value.
●
In tables: activates the edit mode.
TAB
In a dialog box with horizontal tabs only, the key switches the horizontal tabs.
In a dialog box with horizontal and vertical tabs, the key switches the vertical tabs pref-
erably. If the focus is on a horizontal tab, it switches the horizontal tabs.
In a table or diagram, the key moves the focus in the same way as the FIELD RIGHT
key.
UP ARROW, DOWN ARROW
●
In numeric edit fields: increase or decrease the parameter value.
●
In tables: scroll vertically through the rows.
●
In dialog boxes, for option buttons in a column: select an option. In an open selec-
tion list, the keys scroll the list.
LEFT ARROW, RIGHT ARROW
●
In edit fields: move the cursor.
●
In tables: scroll horizontally through the columns.
●
In dialog boxes, for option buttons in a row: select an option.
3.1.8 POWER key
The POWER key is located on the lower left corner of the front panel. It starts up and
shuts down the instrument's software.
See also: chapter 2.3, "Starting the Instrument", on page 14.
3.1.9 Input Connectors
The R&S RTO has two or four channel inputs to connect the input signals using active
and passive probes.
The input connectors are provided with a special Rohde & Schwarz active probe inter-
face, and they are BNC compatible. Thus, the instrument can automatically detect pas-
sive probes with standard BNC connector and active Rohde & Schwarz probes having
the Rohde & Schwarz probe interface.
The input impedance is selectable, the values are 50 Ω and 1 MΩ.
Front Panel
To Next Page
Loading...
