Trying Out the Instrument
R&S
®
RTO
54Getting Started 1316.0833.02 ─ 10
10. Minimize the measurement results display: touch the title of the results box, and
draw it to the signal bar.
11. Close the result icon.
4.7.3 Performing and Configuring the Quick Measurement
A set of up to eight different measurements on one source can be performed at once,
simply by tapping the "Quick measurement" toolbar icon. The results are displayed in a
result box. You can configure the measurement types to be included in quick measure-
ment. This way, repeating measurements are performed very quickly.
In the following example, you will start a quick measurement and change the Quick-
Meas configuration.
1. Press AUTOSET.
2. Tap the "Quick measurement" icon on the toolbar.
Showing Basic Measurement Results
To Next Page
Loading...
