Rohde & Schwarz R&S RTO Series - Entering Data

Operating the Instrument
R&S
®
RTO
90Getting Started 1316.0833.02 ─ 10
To minimize a dialog box
If you need to change only one setting during analysis, and you need to change it
often, you can reduce the dialog box to a small box that only contains the required set-
ting.
1. Tap the function that you need to modify.
2.
Tap the "Minimize" icon in the upper right corner of the dialog box.
The dialog box turns into a small box that contains only the "Wfm Arithmetic" set-
ting.
3.
To restore the complete dialog box, tap the "Maximize" icon in the small box.
To close a dialog box
► Tap the "Close" icon in the upper right corner.
Or:
Press the ESC key on the front panel.
To select an option in a dialog box
► Tap the required option.
Or:
Press the FIELD LEFT and FIELD RIGHT keys to navigate to the required option
and then press the CHECKMARK key.
To select an option in a list
If many options are available - for example, for the trigger type - the options are provi-
ded in a list. The current selection is shown on the list button.
► Tap the list button, and then tap the required option.
Or:
Use the front panel keys:
a) Press the FIELD LEFT and FIELD RIGHT keys to navigate to the list button.
b) Press the CHECKMARK key to open the list.
c) Press the UP ARROW and DOWN ARROW keys to navigate to the required
option in the list.
d) Press the CHECKMARK key to select the marked option.
5.8 Entering Data
Most important parameters have their own rotary knobs on the front panel. The param-
eters on the POSITION and RESOLUTION / RECORD LENGTH keys can be toggled
Entering Data