Trying Out the Instrument
R&S
®
RTO
58Getting Started 1316.0833.02 ─ 10
6. Under "Additional histogram measurements", tap "Activate..." and select the
required results.
The histogram measurement results are displayed in the result box.
7. To finish the measurement, tap the "Close" icon in the result box.
8. To remove the histogram, tap the "Delete" icon on the toolbar and then the histo-
gram. Both the histogram and any measurements based on that histogram are
deactivated.
4.8 Performing an FFT Analysis
During FFT analysis, a signal in the time domain is converted to a spectrum of frequen-
cies. A basic FFT waveform can be displayed very quickly.
The usage of FFT is also shown in a short video that is available on the instrument:
"Tutorials > Getting Started > FFT".
1. Restore the default signal channel settings by pressing the AUTOSET key.
Performing an FFT Analysis
To Next Page
Loading...
