Trying Out the Instrument
R&S
®
RTO
59Getting Started 1316.0833.02 ─ 10
2. Tap the "FFT" icon on the toolbar, then tap the diagram.
A math waveform is configured that uses the "Mag(FFT(x))" operator with
"Ch1Wfm1" as source. The FFT waveform is displayed in a new diagram.
3. To perform a spectrum measurement on the math channel, tap the "Measurement"
icon on the toolbar.
4. Tap the FFT waveform.
The spectrum measurement results are displayed in a result box.
Performing an FFT Analysis
To Next Page
Loading...
