Trying Out the Instrument
R&S
®
RTO
50Getting Started 1316.0833.02 ─ 10
4. Press the RUN ×SINGLE key on the front panel (in the TRIGGER area) to start the
acquisition cycle.
Ten waveform acquisitions are performed. The most recent acquisition is displayed
in the diagram.
5. Press the HISTORY key on the front panel (in the ANALYSIS area).
The quick access "History" dialog box appears and the history mode is enabled.
6. Tap "Play".
The ten stored waveforms are displayed one after the other, but very fast.
7. In the "Current acq." field, enter -4 to display the sixth waveform (counted from
acquisition start). The latest acquisition has the number 0, the oldest has -9.
8.
Tap the icon to open the "History" setup dialog box.
9. Enter -2 in the "Start acq" field, then tap "Newest" to enter 0 in the "Stop acq" field.
Thus the three latest acquisitions will be displayed.
10. In the "Replay time per acq." field, enter 1 s to display each waveform for one sec-
ond.
11. Enable the "Auto repeat" option to see the three waveforms repeatedly.
12. Tap "Play" to start the display.
The currently displayed waveform is indicated in the "Current acq." field.
13. Close the "History" dialog box so you can see the waveform better.
14. Tap "Play" again (now labeled "Running" due to the running display) to stop the
display.
15. Close the quick access "History" dialog box.
The history mode is disabled, and the HISTORY key is no longer illuminated.
Displaying the Waveform History
To Next Page
Loading...
