Trying Out the Instrument
R&S
®
RTO
66Getting Started 1316.0833.02 ─ 10
7.
Tap the
icon in the result box, and select the "Test Definition" tab.
8. Select channel 1 as the "Source".
9. Define the number of tolerable sample hits in the "Tolerance" field.
A test has failed if the number of sample hits exceeds the limit of "Violation toler-
ance" hits.
10. Select the "Event Action / Reset" tab.
11. For the "Stop acquisition" action select On violation. If the violation tolerance is
exceeded, acquisition is stopped.
The results of the mask test are shown in the "MaskTest" results box. Mask hits are
also indicated as red points in the mask segment in the diagram.
Performing a Mask Test
To Next Page
Loading...
