Administration
103
User Manual | 2906.2506.02 - 01
Restoring the System
R&S VENICE S
Once the loading has finished, you will see the Rohde & Schwarz
Rescue script with its options on the screen. Your display should look
similar to the following:
6. To restore your system disk from the internal USB flash drive, press [2]
and then [Enter].
A list of possible target devices will be detailed on the screen. The
system disk normally is the ’ATA’ disk with, for example, ’sda’, ’sdb’ or
’sdc’ as its device name:
(e.g.:
1:0:0:0 disk ATA <device info> /dev/sda).
7. Enter the name of the system disk: Type in e.g. sda (or in other cases
sdb, sdc, etc.) and press [Enter].
A further list of possible source images will be detailed on the screen.
If there is only the Rohde & Schwarz recovery image on the USB flash
drive, this one will be listed. If there are several images, all images will
be displayed.
8. Select the image you want to use for the recovery. Normally, it provides
the serial number of the R&S VENICE S in its name. To confirm your
choice press [Enter].
The system will ask you to confirm your selection and whether you
want to continue.
If you do not perform any action, RuS Rescue will be
loaded automatically after 30 seconds.
Ex factory the R&S VENICE S will be delivered with ’sda’ as
the default system disk. If other configurations have been
made later or on customer request, this may be different.
Data Loss
A recovery will overwrite all your data.
Continue with the following steps only when you are
able to identify the correct target device.
--- RuS Rescue ---
1 - Backup on internal USB device
2 - Restore from internal USB device
5 - Reboot the system
6 - Poweroff the system
0 - Exit
Enter selection:
3 - Backup on self selected external device
4 - Restore from self selected external device
To Next Page
Loading...