Rohde & Schwarz R&S VENICE S800/824-G3 - Page 115

Administration
115
User Manual | 2906.2506.02 - 01
SNMP System Monitoring
R&S VENICE S
AudioReceiverRe-
ceivedPacketsOn-
Leg1
Stream,
Channel,
(Card included
in Channel idx)
Number of pakets
received by the inter-
face for leg 1 (primary
St2022-7 stream)
An increasing count
signals that packets
from the primary
stream have been
received. For St2022-
7 this count should
increase with the
same rate as
ReceivedPacketsOn-
Leg2.
rsSt2110V1Receiver-
AudioCh[Channel]Idx[
Stream]Received-
PacketsOnLeg1
AudioReceiverRe-
ceivedPacketsOn-
Leg2
Stream,
Channel,
(Card included
in Channel idx)
Number of pakets
received by the inter-
face for leg 2
(secondary St2022-7
stream)
An increasing count
signals that packets
from the primary
stream have been
received. For St2022-
7 this count should
increase with the
same rate as
ReceivedPacketsOn-
Leg1.
rsSt2110V1Receiver-
AudioCh[Channel]Idx[
Stream]Received-
PacketsOnLeg2
AncReceiverActive
Stream,
Channel,
(Card included
in Channel idx)
Status of the receiver:
active, inactive
This is always active
as the data point is
not available if the IP
daemon is not
running.
rsSt2110V1Receiver-
AncCh[Channel]Idx[St
ream]Active
AncReceiverOutO-
fOrderPackets
Stream,
Channel,
(Card included
in Channel idx)
The counter
increases if the
packet queue needs
to be reordered
because of missing
sequence numbers.
Signals gaps in
received sequence
numbers. Might indi-
cate missing packets
or a switch to another
sender or stream.
rsSt2110V1Receiver-
AncCh[Channel]Idx[St
ream]OutOfOrder-
Packets
AncReceiver-
DroppedPackets
Stream,
Channel,
(Card included
in Channel idx)
Number of dropped
packets due to full
queue.
An increasing value
indicates that
incoming packets
could not be
processed in time.
Thus the queue is full
and packages need to
dropped.
rsSt2110V1Receiver-
AncCh[Channel]Idx[St
ream]Dropped-
Packets
Data Point Dimension Description Use Case SNMP Name