After printing, use [Sheet Cutting] or [Perforated Sheet Cutting] to separate the media.
Procedure
1. Close the front cover.
2. If necessary, use the following procedure to set the separation position.
(1) Tap .
(2) Tap
[Move].
(3) Tap or to set the media to the separation position.
The media is separated at the position in the following figure. Use the media clamp holes as
a guideline for this position.
(4) Tap [Set Base Point Here].
The separation position is set, and you are returned to the home screen.
3.
Tap [Sheet Cutting] on the operation panel.
4. Select the sheet cutting method.
[
Sheet Cutting]
This separates the media.
[Perforated Sheet Cutting] The media is perforated without being separated.
Separating the Media
104 Basic Operations
To Next Page
Loading...
