[The media could not be detected automatically. Manually set the printing
area.]
This message appears when media with high reflectance is set up. Manually set the printing area.
Procedure
1. Tap [OK] on the screen displaying the above message.
2. Tap [Change].
The [Set the right edge of the printing area within the area specified by the pinch rollers.]
window appears.
3.
Hold down to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B)
from the left edge of the right pinch roller.
4. Tap [OK].
The [Set the left edge of the printing area within the area specified by the pinch rollers.] win-
dow appears.
5. Hold down to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B)
from the right edge of the left pinch roller.
Messages
Messages on the Operation Panel 305
To Next Page
Loading...
