Manual Cleaning Method
If the notification [The time for manual cleaning has arrived.] is displayed or if dot drop-out or ink drip
issues that cannot be improved with powerful cleaning occur, perform manual cleaning.
Be sure to perform operations as specified by the instructions, and never touch any area not
specified in the instructions.
Sudden movement of the machine may cause injury.
WARNING
Important notes on this procedure
• Before attempting this operation, remove any media.
• To prevent the print heads from drying out, finish this procedure in 30 minutes or less. A warning beep sounds after
30 minutes.
• Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may
damage the print heads.
• Do not use cleaning liquid other than the included cleaning liquid.
• Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks will ad-
versely affect the printing results.
• Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the
cleaning liquid.
• Never rub the print head surface (nozzle surface).
• If you use up the cleaning sticks or cleaning liquid, contact your authorized Roland DG Corporation dealer or visit our
website (http://www.rolanddg.com/).
If a warning beep sounds during cleaning
• A warning beep sounds 30 minutes after operation starts. Stop work, close all the covers, and then tap [Finish All]
to end the manual cleaning mode. After that, restart the procedure from the beginning.
Required items
Cleaning sticks Cleaning liquid
IMPORTANT
1. Clean the print head caps.
Procedure
1. Remove any media.
2.
Tap .
3. Tap [Cleaning]>[Manual Cleaning].
4. Tap [Execute].
Cleaning around the Print Heads
232 Regular Maintenance
To Next Page
Loading...
