Is the media loaded correctly?
If the media is not loaded correctly or the media feed is not smooth, output may be adversely affected.
Load the media correctly.
RELATED LINKS
・ P. 30 Setup of New Media
・ P. 67 Setup of Registered Media
Are the settings for the cutting conditions appropriate?
Misalignment or skewing may occur if the cutting speed is too fast or the blade force is too high. Try
changing the cutting conditions. With media having a strong adhesive layer, the adhesive layer reattaches
to itself immediately after cutting. However, if a cutting test shows that the peeling of the media and the
blade traces on the backing paper are optimal, the media is being cut properly. Be careful not to make the
blade force too high.
RELATED LINKS
・ P. 174 Accurately Adjusting the Cutting Settings
Is the length of output too long?
For printing followed immediately by cutting in particular, the longer the page length (that is, the longer
the distance the media is returned after printing), the greater the chance of misalignment occurring. It is
a good idea to keep the size of each single page to the minimum necessary.
Are you using media that exhibits large expansion and contraction?
When you are performing printing followed immediately by cutting, misalignment occurs if the media ex-
pands or contracts. If this happens, try performing printing with crop marks followed by cutting. The cut-
ting position will be corrected to match the expansion and contraction of the media.
RELATED LINKS
・ P. 134 How to Cut with Crop Marks
Is the setting for the [Cutting Distance Correction] menu item (under [Cutting
Settings]) correct?
When you are performing printing followed immediately by cutting, go to [Cutting Settings] and set the
[Cutting Distance Correction] correction value to 0.00%.
RELATED LINKS
・ P. 178 Performing Distance Correction during Cutting
Cutting Is Misaligned, Skewed, or Not Clean
280 Output Quality Problems
To Next Page
Loading...
