Roland TrueVIS SG3-540 - [Replace the Cleaning Liquid Pouch.]; [Install the Cleaning Liquid Pouch.]; [The Time for Ink Mixing Has Arrived.]; [Operation of the Take-Up Unit Stopped.]

To Next Page

To Previous Page

[Replace the cleaning liquid pouch.]

This message appears when a pouch tray with no cleaning liquid pouch is loaded or when there is no

wiper cleaning liquid.

Quickly and correctly insert a new cleaning liquid pouch into the pouch tray and load it in the printer or

replace the empty cleaning liquid pouch.

RELATED LINKS

・ P. 113 Cleaning Liquid Pouch Replacement

[The time for ink mixing has arrived.]

This message appears when it is time to mix the ink.

When [Ink Mixing Notification] accessed with [Preferences]>[Notifications On/Off] is on, this message

appears when 1 week elapses from the last time the ink was mixed.

Tap [The time for ink mixing has arrived.] to display the confirmation screen.

Remove a pouch tray, shake it 50 times (for approximately 20 seconds), and then reinsert it. Perform this

operation for all the pouch trays. On completion, tap [Yes].

[Operation of the take-up unit stopped.]

This message appears and the take-up unit stops when it is not possible to detect the position of the

dancer roller for a continuous length of time during media feeding or pull back.

Tap [Operation of the take-up unit stopped.] and follow the instructions on the screen to recover the

take-up unit.

[Place the middle pinch rollers over all the grit rollers.]

This message appears when the middle pinch rollers have not been properly placed.

Position these pinch rollers properly between the left and right pinch rollers.

Other manuals for Roland TrueVIS SG3-540