Roland TrueVIS SG3-540 - Using Hard-To-Dry Media

Using Hard-to-Dry Media
This setting is used to extend the drying time when the ink dries poorly even if the dryer is used.
Procedure
1. Load the media.
2. Tap .
3. Tap [Media Settings]>[Other Media Settings]>[Drying Time Per Scan].
4.
Tap
or to enter the value.
Larger values cause the media to move more slowly, extending the drying time accordingly.
5. Tap [Save] to confirm your entry.
6. Tap to go back to the original screen.
• Default setting: [
Off]
• Depending on the software RIP you are using, you can also make this setting in the software RIP. When you
have made the setting in the software RIP, the printer's setting is ignored.
MEMO
RELATED LINKS
・ P. 162 Adjusting the Ink-drying Method
Configuring Settings to Match the Properties of the Media
Optimizing the Output Quality 155