Roland TrueVIS SG3-540 - Accurately Adjusting the Settings for Cutting with Crop Marks; Correcting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Printing and Cutting with Crop Marks); Correcting the Misalignment of Printing and Cutting with Crop Marks; Rent Test for Printing and Cutting with Crop Marks)

Correcting the Misalignment of Printing and Cutting with Crop Marks (Concur-
rent Test for Printing and Cutting with Crop Marks)
Depending on the composition of the media, the positioning of printing and cutting may be misaligned
even when you are using crop marks. Make corrections for misaligned printing and cutting for the media
you are using.
In cutting with crop marks, cutting is performed after removing the media after printing. However, with
this method, you can make corrections of printing and cutting positions at the same time without removing
the media.
1. Adjust the misalignment of the ink landing position.
Procedure
1. Load the media.
2. Tap .
3. Tap [Media Settings]>[Printing Settings]>[Media Gap Adjustment].
4. Select [Simple Correction (Auto)] and tap [Next].
5. Tap [Execute].
The test pattern is printed and the media gap is adjusted automatically.
6. Tap [OK] when the completion screen appears.
7. Perform the operations shown below according to the [Result].
• If [Successful] is displayed on the operation panel, tap to go back to the original
screen.
• If [Failed] is displayed on the operation panel, manually adjust the media gap.
RELATED LINKS
・ P. 151 Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjust-
ment)
Accurately Adjusting the Settings for Cutting
with Crop Marks
Optimizing the Output Quality 187