Roland TrueVIS SG3-540 - The Media Heating System Doesnt Warm up; Is the Media Loaded; Is [Heater Power] Turned on; Is the Temperature of the Room too Low

Is the media loaded?
By default, simply switching on the power does not make the media heating system warm up to the preset
temperature. Load the media and wait for the machine to warm up.
RELATED LINKS
・ P. 162 Adjusting the Ink-drying Method
Is [Heater Power] turned on?
If [Cut Only] is selected for [Select Media Output Type] in the media setup, [Heater Power] is set to [Off]
and the media heating system does not heat up. Perform setup again with the [Print Only/Print & Cut]
output type or set [Heater Power] to [On].
RELATED LINKS
・ P. 30 Setup of New Media
・ P. 67 Setup of Registered Media
・ P. 172 Switching Off the Print Heater and Dryer Together
Is the temperature of the room too low?
The media heating system may not warm up sufficiently when the ambient temperature is less than 20°C
(68°F). Also, even when the media heating system reaches its set temperatures, adequate effectiveness
may not be apparent if the media is thoroughly chilled. Before printing, allow the media to come to room
temperature.
The Media Heating System Doesn't Warm Up
Machine Problems 299