Turning the Power Off
Remove any loaded media or switch off the sub power when printing is not being performed.
The continued application of heat at a single location may cause the release of toxic gases from the media or pose a
fire hazard.
WARNING
Procedure
1.
When printing is complete, tap
on the operation panel.
The confirmation screen appears.
2. Tap [Yes].
The sub power switches off automatically.
3. Raise the loading lever and remove the media.
If you will leave the sub power on while not using the machine, set it as shown below.
• Raise the loading lever.
• Lower the dancer roller toward the rear.
Power Supply Operations
26 Basic Operations
To Next Page
Loading...
