Roland TrueVIS SG3-540 - Managing the Media Settings; Changing the Media Settings

Changing the Media Settings
Use the following procedure to change the media settings. These settings can only be changed for the me-
dia being set up.
Procedure
1. Load the media.
2.
Tap
.
3. Tap [Media Settings]>[List of Media Settings].
4. Tap the setting to change to move to the screen for editing this setting.
The media settings that can be changed are as follows.
Menu item
Reference page
[Print Head Height]
P. 153Changing the Print Head Height
[Feed Correction]
P. 149Manual Adjustment: Reducing Hori-
zontal Bands (Feed Correction Function)
[Media Gap Adjustment]
P. 151Manual Adjustment: Adjusting the
Misalignment of the Ink Landing Position
(Media Gap Adjustment)
[Blade Adjustment]
P. 174Fine-tuning the Cutting Conditions
[Print & Cut Position Adjustment]
P. 182Correcting the Misalignment of
Printing and Cutting
[Crop Cut Position Adjustment]
P. 187Correcting the Misalignment of
Printing and Cutting with Crop Marks (Con-
current Test for Printing and Cutting with
Crop Marks)
P. 190Correcting the Misalignment of
Printing and Cutting with Crop Marks (Sepa-
rate Test for Printing/Cutting with Crop
Marks)
[Cutting Distance Correction]
P. 178Performing Distance Correction
during Cutting
[Over Cut]
P. 179Cutting to Make It Possible to Cut
Corners Attractively (Over Cut)
[Heater Temperature]
P. 164Setting the Print Heater Tempera-
ture
P. 166Setting the Dryer Temperature
[Dry After Printing]
P. 170Drying the Trailing Edge of the
Printing Area on the Dryer
Managing the Media Settings
196 Optimizing Work Efficiency