[Pinch Lever Error]
The loading lever was raised during media setup or after completing this setup.
Lower the loading lever and redo setup.
[Media Loading Error]
This message appears when [Media Edge Detection] is set to [Enable] and media has not been fed with
the pinch rollers set incorrectly.
Raise the loading lever, set the pinch rollers correctly, and then set up the media again.
This message appears when [Media Edge Detection] is set to [Enable] and the media is too short.
The media is not long enough to be detected. Raise the loading lever, set [Media Edge Detection] to [Disa-
ble], and then reload the media.
For the setup method when [Media Edge Detection] is set to [Disable], refer to 1. B: Determine the posi-
tions of the media ([Media Edge Detection]: [Disable]).(P. 58).
RELATED LINKS
・ P. 30 Setup of New Media
・ P. 67 Setup of Registered Media
[Drain Bottle Error]
This message appears when the drain bottle has reached its limit for discharged fluid.
Discard the discharged fluid in the drain bottle, and then attach this bottle again.
When the drain bottle is detached, the error message changes to [
Install the drain bottle.].
MEMO
This message appears when the drain bottle is misaligned.
Install the drain bottle again.
[Crop Mark Detection Error]
[Crop marks could not be detected.]
Automatic detection of crop marks could not be accomplished.
Try to make corrections using [Multi Sensor Adjustment] (the correction function of the sensor for reading
crop marks). Depending on the media, it may not be possible to detect crop marks automatically.
[Crop marks were detected however the size or position was incorrect.]
Automatic detection of crop marks could not be accomplished.
Load the media at the correct position and perform detection of crop marks again. If repeating automatic
crop-mark detection also results in an error, start over again from the printing of crop marks.
RELATED LINKS
・ P. 30 Setup of New Media
・ P. 67 Setup of Registered Media
Error Messages
308 Messages on the Operation Panel
To Next Page
Loading...
