Roland TrueVIS SG3-540 - Messages on the Operation Panel

Messages on the Operation
Panel
Messages ............................................................................................... 302
[When output, cleaning, and other operations are completed, discard the
discharged fluid.] ....................................................................... 302
[The time for manual cleaning has arrived.] ............................................ 302
[The time for wiper replacement has arrived.]......................................... 302
[The time for wiper tray cleaning has arrived.] ........................................ 302
[Print head protection mode has activated.]............................................ 302
[Replace the cleaning liquid pouch.]...................................................... 303
[Install the cleaning liquid pouch.] ........................................................ 303
[The time for ink mixing has arrived.].................................................... 303
[Operation of the take-up unit stopped.] ................................................ 303
[Place the middle pinch rollers over all the grit rollers.]............................. 303
[Install the media clamps correctly.] ...................................................... 303
[Media clamps could not be detected.]................................................... 304
[The LAN cable is not connected.] ........................................................ 304
[Connection is requiring too much time. Manually setting the IP address
will improve the connection speed.] ............................................... 304
[The media could not be detected automatically. Manually set the printing
area.] ...................................................................................... 305
Error Messages ........................................................................................ 307
[Ink Pouch Tray Error] ........................................................................ 307
[Cover Open Error]............................................................................ 307
[Media End Error] ............................................................................. 307
[Pinch Lever Error] ........................................................................... 308
[Media Loading Error] ........................................................................ 308
[Drain Bottle Error] ........................................................................... 308
[Crop Mark Detection Error] ................................................................ 308
[Unable to Fill Wiper Cleaning Liquid] .................................................... 309
[Pinch Roller Error] ........................................................................... 309
[Print Head Height Mismatch] .............................................................. 309
[Insufficient Media Width]................................................................... 309
[Motor Error] ................................................................................... 310
[Print Head Dry-out Error] .................................................................. 310
[Low Temperature Error] .................................................................... 310
[High Temperature Error].................................................................... 311
[Pump Stop Error] ............................................................................. 311
[Cleaning Error (Ink Pouch Tray)] .......................................................... 311
[Cleaning Error (Drain Bottle)].............................................................. 311
[Take-up Unit Communication Error]...................................................... 311
[Service Call] ................................................................................... 311
[Software error] ............................................................................... 312
Messages on the Operation Panel
301