Machine Problems
The Print Heads Do Not Move ....................................................................... 294
What to Do First ................................................................................ 294
If the Print Heads Still Do Not Move ......................................................... 294
The printer unit does not run....................................................................... 296
Is the power switched on? .................................................................... 296
Is [Output possible.] displayed? ............................................................. 296
Are any covers open? .......................................................................... 296
Is the message [Output is currently paused.] displayed on the screen? ............. 296
Is a message displayed on the screen? ...................................................... 296
Are the cables connected?.................................................................... 296
Is the LAN routing appropriate? .............................................................. 297
Are the LAN settings correct? ................................................................ 297
Did the software RIP end abnormally? ...................................................... 297
Is an [Ink Pouch Tray Error] displayed? .................................................... 297
The Media Heating System Doesn't Warm Up..................................................... 299
Is the media loaded?........................................................................... 299
Is [Heater Power] turned on? ................................................................ 299
Is the temperature of the room too low?................................................... 299
Cannot Separate the Media ......................................................................... 300
Is the separating knife installed? ............................................................ 300
Machine Problems
293
To Next Page
Loading...
