• When you send the output data, [Ink circulation in progress.] or [Normal cleaning in progress.] may be
displayed on the screen. These indicate the preparation operations performed before output. Output will
begin after the time displayed on the screen elapses.
• If [Heater warm up in progress. Please wait.] is displayed, wait until the set temperature is reached.
• The data being output can be viewed as an image. Tap shown in the following figure to switch to the
remaining ink screen. Tap this icon again to return to the screen for checking the data being output. How-
ever, this functionality is limited to software RIPs that support the display of the output data image
(thumbnail).
MEMO
Output Is Not Possible in These Situations
• The machine does not run when a cover (front, left, or right) is open.
• Data from the computer is not accepted when [Load media.] is displayed.
• Output does not start while [Heater warm up in progress. Please wait.] is displayed.
• On menu screens where [Menu operation in progress: Press [Home] to enable output.] is displayed, out-
put doesn't start even when data is sent from the computer. When you return to a menu item where output
is possible or tap to return to the home screen, output starts.
Points that must be observed
• Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.
• When you are performing printing, clamp the edges of the media with the media clamps. Otherwise, the
edges of the media may warp and catch on the print heads.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub
against the print heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
When not using the machine, remove any media and store it in a suitable environment.
• If the machine is left with the media loaded, the media may be damaged, which may adversely affect
printing. When not using the machine, remove any media and store it in a suitable environment.
IMPORTANT
RELATED LINKS
・ P. 164 Setting the Print Heater Temperature
・ P. 166 Setting the Dryer Temperature
・ P. 172 Switching Off the Print Heater and Dryer Together
Starting Output with Crop Marks
How to Cut with Crop Marks 141
To Next Page
Loading...
