Adjust the reading sensor to the optimal condition. If the adjustment failed, respond to the
failure according to the information in Correcting the Reading Sensor(P. 199).
c. Tap [Next].
d. Perform a printing test on the [Detailed Feed Correction (Manual)] screen.
Set the correction value from the printing test result. For more information, refer to Man-
ual Adjustment: Reducing Horizontal Bands (Feed Correction Function)(P. 153).
e. Tap [Save and Proceed].
f. Perform a printing test on the [Detailed Media Gap Adjustment (Manual)] screen.
Set the correction values from the printing test result. For more information, refer to Man-
ual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjust-
ment)(P. 155).
g. Tap [Save and Exit].
This completes the setup of the media.
Setup of New Media
68 Basic Operations
To Next Page
Loading...
