6. Place the media on the media stays.
Place the media stays at positions that are 1/4 the length of the media from each end of the media.
MEMO
Do not leave media on the media stays for a long period of time. The media may become deformed.
IMPORTANT
7. Fit the paper tube (core) of the media onto the end cap of the left media holder.
8. Move the right media holder to fit its end cap onto the paper tube (core) of the media.
Fit the paper tube onto the media holders securely to prevent the media from moving easily.
Do not secure the media holders in place just yet.
In the following procedure, you will adjust the positions of the media holders before securing them in place.
Do not secure them in place just yet.
IMPORTANT
Setup of Registered Media
Basic Operations 71
To Next Page
Loading...
