9. Move the left and right pinch rollers, placing them on both edges of the media.
Position them approximately 10 mm (0.39 in.) from each edge of the media.
Be sure to use the left and right pinch rollers. The force with which the media is pinched varies between the
middle pinch rollers and the left and right pinch rollers. Using the middle pinch rollers to pinch the media
edges will lead to unstable media feeding.
IMPORTANT
To smoothly move the pinch rollers, push down close to the rail.
MEMO
10. Move the middle pinch rollers (B) over all the remaining grit rollers (A) covered by the media.
There are grit patterns (C) wherever there are grit rollers.
Setup of Registered Media
96 Basic Operations
To Next Page
Loading...
