A-11
Appendix A
Message Description
OFF KEY DISABLED Appears when the user attempts to turn the HC off before
sending modified data or before completing a method.
Online device disconnected with
unsent data. RETRY or
OK to lose data.
There is unsent data for a previously connected device.
Press RETRY to send data, or press OK to disconnect
and lose unsent data.
Out of memory for hotkey
configuration. Delete
unnecessary items.
There is no more memory available to store additional
hot key items. Unnecessary items should be deleted to
make space available.
Overwrite existing
configuration memory
Requests permission to overwrite existing configuration
either by a device-to-memory transfer or by an offline
configuration. User answers using the softkeys.
Press OK... Press the OK softkey. This message usually appears
after an error message from the application or as a result
of HART communications.
Restore device value? The edited value that was sent to a device was not
properly implemented. Restoring the device value
returns the variable to its original value.
Save data from device to
configuration memory
Prompts user to press SAVE softkey to initiate a device-
to-memory transfer.
Saving data to
configuration memory.
Data is being transferred from a device to
configuration memory.
Sending data to device. Data is being transferred from configuration
memory to a device.
There are write only variables
which have not been edited.
Please edit them.
There are write-only variables which have not been set
by the user. These variables should be set or invalid
values may be sent to the device.
There is unsent data. Send it
before shutting off?
Press YES to send unsent data and turn the HC off.
Press NO to turn the HC off and lose the unsent data.
Too few data bytes received Command returns fewer data bytes than expected as
determined by the device description.
Transmitter Fault Device returns a command response indicating a fault
with the connected device.
Units for <variable label> has
changed. Unit must be sent before
editing, or invalid data will be sent.
The engineering units for this variable have been
edited. Send engineering units to the device before
editing this variable.
Unsent data to online device. SEND
or LOSE data.
There is unsent data for a previously connected device
which must be sent or thrown away before connecting to
another device.
Use up/down arrows to change
contrast. Press DONE when done.
Gives direction to change the contrast of the HC display.
Value out of range
The user-entered value is either not within the range for
the given type and size of variable or not within the min/
max specified by the device.
<message> occurred reading/
writing <variable label>
Either a read/write command indicates too few data
bytes received, transmitter fault, invalid response code,
invalid response command, invalid reply data field, or
failed pre- or post-read method; or a response code of
any class other than SUCCESS is returned reading a
particular variable.
<variable label> has an unknown
value. Unit must be sent before
editing, or invalid data will be sent.
A variable related to this variable has been edited. Send
related variable to the device before editing this variable.
To Next Page
Loading...
