Rosemount Model 8732C Integral Mount Magnetic Flowmeter System
4-2
SAFETY MESSAGES
Instructions and procedures in this section may require special
precautions to ensure the safety of the personnel performing
the operations. Information that raises potential safety issues is
indicated by a warning symbol ( ). Please refer to the following safety
messages before performing an operation preceded by this symbol.
Explosions could result in death or serious injury:
• Verify that the operating atmosphere of the flowtube and transmitter is
consistent with the appropriate hazardous locations certifications.
• Do not remove the transmitter cover in explosive atmospheres
when the circuit is alive.
• Before connecting a HART-based communicator in an explosive
atmosphere, make sure the instruments in the loop are
installed in accordance with intrinsically safe or non-incendive field
wiring practices.
• Do not make connections to the HART Communicator’s serial port or
NiCad recharger jack in an explosive atmosphere.
• Both transmitter covers must be fully engaged to meet
explosion-proof requirements.
Failure to follow safe installation and servicing guidelines could result in
death or serious injury:
• Make sure only qualified personnel perform these procedures.
• Do not perform any service other than those contained in this manual
unless qualified.
High voltage that may be present on leads could cause electrical shock:
• Avoid contact with leads and terminals.
To Next Page
Loading...
