Rosemount 8732C - Section 3 Local Operator Interface; The Local Operator Interface (LOI); Safety Messages

Section
3-1
3 Local Operator Interface
THE LOCAL OPERATOR
INTERFACE (LOI)
The LOI option is an operator communications center for the Model
8732C. Through the LOI, the operator can access any transmitter
function for changing configuration parameter settings, checking
totalized values, or other functions.
SAFETY MESSAGES
Instructions and procedures in this section may require special
precautions to ensure the safety of the personnel performing the
operations. Information that raises potential safety issues is indicated
by a warning symbol ( ). Please refer to the following safety messages
before performing an operation preceded by this symbol.
Explosions could result in death or serious injury:
• Verify that the operating atmosphere of the flowtube and transmitter is
consistent with the appropriate hazardous locations certifications.
• Do not remove the transmitter cover in explosive atmospheres
when the circuit is alive.
• Both transmitter covers must be fully engaged to meet
explosion-proof requirements.
Failure to follow safe installation and servicing guidelines could result in
death or serious injury:
• Make sure only qualified personnel perform these procedures.
• Do not perform any service other than those contained in this manual
unless qualified.
High voltage that may be present on leads could cause electrical shock:
• Avoid contact with leads and terminals.