Programming Cards and Tags
CP-R25 Hardware and AS-B01 Software Manual 25
If the programming fails, there is a short buzz and the Swipe Card Reader
LEDs light red for three seconds.
5.2.2 Fingerprint Swipe Reader Configuration Cards
The Fingerprint Swipe Reader Configuration card allows you to create a
Configuration card to configure the various Fingerprint Swipe readers such as
the AY-B1663, AY-B3663, and AY-B4663.
To prepare a Biometric Swipe Configuration Card:
1. Select the CPR-25 tab.
2. In
Operation Mode
, select either Sector or Card Serial Number (CSN).
3. In
Card Type
, select either Mifare
®
1 K or Mifare
®
4 K.
4. From the
Transmit Format
dropdown menu, select the applicable
transmission format.
5. For Sector operation mode, define the
ID Location
using the Sector
Number, Block Number, and Byte Number fields.
6. From the
Operation Type
dropdown menu, select Program
Configuration Card.
7. Ensure that the
Operations
is set to Program Card.
8. Define the
Led and Buzzer Control
behavior by selecting or clearing the
Enable Led and Enable Buzzer checkboxes.
9. To enable the
Lockout
feature:
a. Select the Enable checkbox.
b. Define the lockout behavior using the Attempts and Duration
fields.
10. For reports on operational failures, select the Enable checkbox under
Failed operation reporting
.
11. In
KeyA
, enter the KeyA to be used by the reader as the unique KeyA for
the organization or site in both the Reader KeyA and the Confirm
Reader KeyA fields.
The KeyA number is hidden by "*" characters, so write down the new key
and keep it in a safe place to avoid exposing this secret key to unauthorized
personnel. The KeyA value is entered as a 12 hexadecimal digit. The default
KeyA is FFFFFFFFFFFF.
12. Place a blank Mifare
®
card or a card previously configured as a
Configuration Card on the CP-R25 Desktop Programmer antenna area.
13. Click Start to begin programming the Mifare
®
card.
On completion, a message appears in the Message Log area to verify that
the programming succeeded.
If the programming fails, there is a short buzz and the swipe Card Reader
LEDs light red for three seconds.
To Next Page
Loading...
Need help?
General
